This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
pic32mx270f256b [2019/05/09 02:55] sausage |
pic32mx270f256b [2021/12/12 06:12] sausage |
||
---|---|---|---|
Line 28: | Line 28: | ||
* Pin 2 (RA0) to the positive side of an LED. Negative side of the LED to a 10 Ohm resistor. Then to GND. | * Pin 2 (RA0) to the positive side of an LED. Negative side of the LED to a 10 Ohm resistor. Then to GND. | ||
* Pin 3 (RA1) to the positive side of an LED. Negative side of the LED to a 10 Ohm resistor. Then to GND. | * Pin 3 (RA1) to the positive side of an LED. Negative side of the LED to a 10 Ohm resistor. Then to GND. | ||
- | |||
- | {{ :pic32mx270f256b-breadboard-components.jpg?nolink |}} | ||
On both the Power and Ground rails on the breadboard, add a 0.1uf capacitor each. | On both the Power and Ground rails on the breadboard, add a 0.1uf capacitor each. | ||
- | Also between Pin 20 (CAP) and Pin 9 (VSS) add a 0.01uf capacitor. | + | Also between Pin 20 (CAP) and Pin 19 (VSS) add a 0.01uf capacitor. |
Add a 10k pull up resistor from Pin 1 (MCLR) to Power. MCLR is Master Clear or Reset. | Add a 10k pull up resistor from Pin 1 (MCLR) to Power. MCLR is Master Clear or Reset. | ||
Line 39: | Line 37: | ||
That should be the minimum required to test the microcontroller. | That should be the minimum required to test the microcontroller. | ||
+ | {{ :pic32mx270f256b-breadboard-components.jpg?nolink |}} | ||
You can also get a diagram of the recommended setup on [[https://docs-apac.rs-online.com/webdocs/1385/0900766b8138548d.pdf#G3.1116201|page 28 of the PIC32MX270F256B Datasheet]], Figure 2-1. | You can also get a diagram of the recommended setup on [[https://docs-apac.rs-online.com/webdocs/1385/0900766b8138548d.pdf#G3.1116201|page 28 of the PIC32MX270F256B Datasheet]], Figure 2-1. |