pic32mx270f256b
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
pic32mx270f256b [2019/05/09 02:48] sausage [Minimum setup for a PIC32MX270F256B on a Breadboard + PICkit3] |
pic32mx270f256b [2019/05/29 07:54] sausage |
||
|---|---|---|---|
| Line 28: | Line 28: | ||
| * Pin 2 (RA0) to the positive side of an LED. Negative side of the LED to a 10 Ohm resistor. Then to GND. | * Pin 2 (RA0) to the positive side of an LED. Negative side of the LED to a 10 Ohm resistor. Then to GND. | ||
| * Pin 3 (RA1) to the positive side of an LED. Negative side of the LED to a 10 Ohm resistor. Then to GND. | * Pin 3 (RA1) to the positive side of an LED. Negative side of the LED to a 10 Ohm resistor. Then to GND. | ||
| - | |||
| - | {{ :pic32mx270f256b-breadboard-components.jpg?nolink |}} | ||
| On both the Power and Ground rails on the breadboard, add a 0.1uf capacitor each. | On both the Power and Ground rails on the breadboard, add a 0.1uf capacitor each. | ||
pic32mx270f256b.txt ยท Last modified: 2021/12/14 12:07 by sausage
Page Tools
