User Tools

Site Tools


pic32mx270f256b

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision Both sides next revision
pic32mx270f256b [2019/05/09 02:55]
sausage
pic32mx270f256b [2019/05/29 07:53]
sausage
Line 10: Line 10:
  
 {{ :​pic32mx270f256b-pins.png?​nolink |}} {{ :​pic32mx270f256b-pins.png?​nolink |}}
 +{{ :​pic32mx270f256b-breadboard-components.jpg?​nolink |}}
 Here is the overall layout on the breadboard: Here is the overall layout on the breadboard:
  
Line 28: Line 28:
   * Pin 2 (RA0) to the positive side of an LED. Negative side of the LED to a 10 Ohm resistor. Then to GND.   * Pin 2 (RA0) to the positive side of an LED. Negative side of the LED to a 10 Ohm resistor. Then to GND.
   * Pin 3 (RA1) to the positive side of an LED. Negative side of the LED to a 10 Ohm resistor. Then to GND.   * Pin 3 (RA1) to the positive side of an LED. Negative side of the LED to a 10 Ohm resistor. Then to GND.
- 
-{{ :​pic32mx270f256b-breadboard-components.jpg?​nolink |}} 
  
 On both the Power and Ground rails on the breadboard, add a 0.1uf capacitor each. On both the Power and Ground rails on the breadboard, add a 0.1uf capacitor each.
Line 39: Line 37:
 That should be the minimum required to test the microcontroller. ​ That should be the minimum required to test the microcontroller. ​
  
 +{{ :​pic32mx270f256b-breadboard-components.jpg?​nolink |}}
  
 You can also get a diagram of the recommended setup on [[https://​docs-apac.rs-online.com/​webdocs/​1385/​0900766b8138548d.pdf#​G3.1116201|page 28 of the PIC32MX270F256B Datasheet]],​ Figure 2-1. You can also get a diagram of the recommended setup on [[https://​docs-apac.rs-online.com/​webdocs/​1385/​0900766b8138548d.pdf#​G3.1116201|page 28 of the PIC32MX270F256B Datasheet]],​ Figure 2-1.
pic32mx270f256b.txt ยท Last modified: 2021/12/14 12:07 by sausage