This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Last revision Both sides next revision | ||
repairing_adafruit_grand_central [2021/12/01 21:13] sausage [The board arrives] |
repairing_adafruit_grand_central [2021/12/01 22:44] sausage [Fault finding] |
||
---|---|---|---|
Line 15: | Line 15: | ||
===== Fault finding ===== | ===== Fault finding ===== | ||
- | My first step was to test if I could read +5V at the micro USB connector. Yep, 5V. So that rules out a damaged connector, or not being connected to the PCB. | + | My first step was to test if I could read +5V at the micro USB connector. Yep, I had 5V there at the pin. So that rules out a damaged connector, or not being connected properly to the PCB. |
The next was to trace the 5V line. From the USB 5V pin, a trace ran through a small fuse. Testing the fuse with a continuity test, that was fine and I got 5V on either side of the fuse. | The next was to trace the 5V line. From the USB 5V pin, a trace ran through a small fuse. Testing the fuse with a continuity test, that was fine and I got 5V on either side of the fuse. |