start
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
start [2026/07/04 11:45] sausage |
start [2026/10/15 03:04] (current) sausage [AirFlash for the Pi Zero] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | ====== STM32/Nucleo LoRa project quick start ====== | ||
| + | |||
| + | [[stm32-nucleo-lora-quickstart|{{::stm32:stm32-nucleo-lora-module-breadboard.jpg?direct&400| }}]] | ||
| + | |||
| + | Following up from last weeks ESP32 LoRa quick start, here is a version for the STM32, and specifically Nucleo F303K8 or similar. | ||
| + | |||
| + | So if you need to slap together a quick LoRa-based project on an STM32 NUCLEO-F303K8 using STM32CubeIDE for testing, follow along here. | ||
| + | |||
| + | [[stm32-nucleo-lora-quickstart|Read Article]] | ||
| + | |||
| + | ====== ESP32/esp-idf LoRa project quick start ====== | ||
| + | |||
| + | [[esp32-espidf-lora-quickstart|{{:lora:rfm95-lora.jpg?direct&400 |}}]] | ||
| + | |||
| + | If you need to bang together a quick LoRa-based project on an ESP32 using esp-idf (not Arduino) so you can get going in a hurry, follow along here. | ||
| + | |||
| + | The focus on this quick start is to aim for 915MHz. Our setup will be configured to pull Meshcore packets out of air configured for the Australian NSW/ACT Regional settings. But you can easily change this for your region. | ||
| + | |||
| + | [[esp32-espidf-lora-quickstart|Read Article]] | ||
| + | |||
| ====== Attending ElectroneX 2026 ====== | ====== Attending ElectroneX 2026 ====== | ||
| Line 25: | Line 45: | ||
| [[first_weeks_with_the_commodore_64u|Read Article]] | [[first_weeks_with_the_commodore_64u|Read Article]] | ||
| + | |||
| + | ---- | ||
| ====== Nordic NRF9151, Zephyr Message Queues, C++ and troubleshooting the less obvious ====== | ====== Nordic NRF9151, Zephyr Message Queues, C++ and troubleshooting the less obvious ====== | ||
| Line 38: | Line 60: | ||
| [[nrf9151_zephyr_queues_cpp_trouble|Read Article]] | [[nrf9151_zephyr_queues_cpp_trouble|Read Article]] | ||
| + | |||
| + | ---- | ||
| ====== My time at Commodore ====== | ====== My time at Commodore ====== | ||
| Line 320: | Line 344: | ||
| [[airflash|{{:airflash:airflash.jpg?direct&300 |}}]] | [[airflash|{{:airflash:airflash.jpg?direct&300 |}}]] | ||
| - | The AirFlash is an open-source standalone USB powered device that accepts up to four USB Flash drives and will serve their content out over WIFI to one or more users. | + | The AirFlash is an open-source standalone USB powered embedded Linux device that accepts up to four USB Flash drives and will serve their content out over WIFI to one or more users. |
| You can take it anywhere and plug it in to a USB power source. Within 90 seconds the device will be available. | You can take it anywhere and plug it in to a USB power source. Within 90 seconds the device will be available. | ||
start.1783165525.txt.gz ยท Last modified: 2026/07/04 11:45 by sausage
Page Tools
